- Run machine at 520-550 revs for wheat & barley.
- This is measured by pointing RPM metre at bottom of auger with tab on it.
- Black lever near hydraulic hoses is to control hydraulic flow, to set speed.
- Ensure you slow machine down prior to turning off, as you should not restart machine on full on full revs.
- Yellow handle is to control flow of grain into machine to ensure even flow to all tubes.
- The steeper you run the machine the more screenings etc the machine will take out.
- Ensure to stop grain and allow cleaner to empty out at finish of each run. Makes it much easier to restart machine or shift.
- If changing screens, ensure to refit with seam facing clockwise.
- Clean down screens and machine at finish of hire, to the standard it was provided.
- There are 2 slides at bottom of machine to was machine out.